Roverpet 66PR Assembly Instructions

6'x 6' puppy rail

Table of Contents

Download this manual

Roverpet

20 Kiji Dava Circle Prescott, Arizona 86301

Roverpet #66PR – 6'x 6' Puppy Rail Assembly Instructions

Inventory List for The Roverpet #66PR Puppy Rail System:

(2) #PR72LB 72" Long Support Bar

(6) 2", 3", 4", 5", 6" or 8" high legs (depending on style of Roverpet Puppy Rail System ordered)

Assembly Procedure

Special Notes: If your Roverpet 6'x6' whelping box consists of a door panel, it needs to be configured with the door located on

Assembly of the Roverpet Puppy Rail System needs to be done outside of your existing Roverpet whelping box, than installed

1.) Unpack contents of shipping carton and compare to inventory list above.

2.) Install (4) legs of the Roverpet Puppy Rail System into the 4 small leg whole locations on both #PR72LB.

(2) #72CB 72" Long Crossbar

the right or center of the whelping box side to allow door hinge clearance.

into the whelping box once fully assembled.

800-658-5925

rover@roverpet.com

(2) #PRS66 Crossbar Support and

Page 1 of 3

Table of Contents

Do you have a question about the 66PR and is the answer not in the manual?

Page 1 (6) 2”, 3”, 4”, 5”, 6” or 8” high legs (depending on style of Roverpet Puppy Rail System ordered) Assembly Procedure Special Notes: If your Roverpet 6’x6’ whelping box consists of a door panel, it needs to be configured with the door located on the right or center of the whelping box side to allow door hinge clearance.
Page 2 4 legs installed in Step 2 are positioned in the same direction. 6.) Take the assembled Roverpet Puppy Rail System and lower one side of the rails into your Roverpet whelping box. Line up the #PR72LB connecting ends with the 2nd vertical bars of the whelping box panels.
Page 3 7.) Clip the #PR72LB connecting ends around the vertical bars. 8.) With the one side of the #PR72LB installed on the vertical bars, slide the high-side of the Roverpet Puppy Rail System down into the Roverpet whelping box. Make sure the #PR72LB connecting ends are installed in the same manner as in the prior step.