Vitek VT-3629 Manual Instruction page 3

MEAT GRINDER VT-3629
The meat grinder is intended for processing
products and making homemade semi-fin-
ished products.
DESCRIPTION
Pusher
1.
Food tray
2.
Meat grinder head body
3.
Meat grinder head installation place
4.
Meat grinder head lock button
5.
Meat grinder body
6.
Operation mode switch (ON/0/R)
7.
Screw
8.
Crossed blade
9.
Food processing plate
10.
Meat grinder head nut
11.
ATTENTION!
For additional protection it is reasonable to
install a residual current device (RCD) with
nominal operation current not exceeding
30 mA. To install an RCD contact a spe-
cialist.
SAFETY MEASURES
Read this instruction manual carefully before
using the unit and keep it for the whole unit
operation period. Mishandling of the unit may
lead to its breakage and cause harm to the user
or damage to his/her property.
To reduce the risk of fire, to prevent electric
shock and to avoid other injuries, it is neces-
sary to observe the following safety measures
when using the electric meat grinder:
•
Before switching the unit on for the first time,
make sure that the voltage in your mains
corresponds to the operating voltage of the
unit.
•
Use only the accessories supplied with the
unit.
• To avoid electric shock, NEVER IMMERSE
the unit, the power cord and the power plug
into water or any other liquids.
•
Use a slightly damp cloth to clean the meat
grinder body and then wipe the unit body
dry.
• Never leave the operating meat grinder
unattended.
IM VT-3629.indd 3
•
Always switch the meat grinder off and
unplug it before assembling, disassembling
and cleaning.
•
Place the unit on a flat steady surface away
from heat sources, open flame, moisture
and direct sunlight.
• Do not set the unit on a heated surface or
next to it (for instance, near a gas or elec-
tric stove, near a heated oven or a cooking
surface).
•
Handle the power cord with care, prevent
it from multiple twisting and straighten the
power cord periodically.
•
Do not use the power cord for carrying the
meat grinder.
•
Do not let the power cord hang from the
edge of a table, and make sure that the cord
does not touch sharp furniture edges and
hot surfaces.
•
When unplugging the unit from the mains,
hold the power plug but not the cord.
• Do not connect or disconnect the power
cord from the mains and do not touch it with
wet hands, this may cause electric shock.
•
This unit is not intended for usage by chil-
dren.
• Do not allow children to use the unit as a toy
and do not allow them to touch the unit body
and the power cord during the operation.
•
During operation and breaks between oper-
ation cycles, the unit should be placed out
of reach of children.
• The unit is not intended for usage by
physically or mentally disabled persons
(including children) or by persons lack-
ing experience or knowledge if they are
not under supervision of a person who is
responsible for their safety or if they are
not instructed by this person on the usage
of the unit.
•
For children safety reasons do not leave
polyethylene bags, used as packaging,
unattended.
Attention! Do not let children play with poly-
ethylene bags or packaging film. Danger of
suffocation!
• Do not attempt to repair the unit. Do not
disassemble the unit, if any malfunction is
detected or after it was dropped, unplug
3
ENGLISH
11.07.2018 12:47:40