Regulatory Model Number; Safety And Regulatory Compliance - Aruba 500 Series Installation Manual

Environmental
Operating:

Temperature: 0°C to +50°C (+32°F to +122°F)

Humidity: 5% to 93% non-condensing

Storage and transport:

Temperature: -40°C to +70°C (-40°F to +158°F)

Humidity: 5% to 93% non-condensing

!
The Aruba 500 Series access points are for indoor use only. The access point, AC adapter, and all connected
cables are not designed for outdoor use.
!
This device is intended for stationary use in partly temperature controlled weather-protected environments.
BLE Radio Default State
When the Access Point is in factory default state the integrated BLE radio is enabled. This applies to the non-TAA/
FIPS product SKUs only. On the TAA/FIPS products, the BLE radio is disabled when the unit is in factory default
conditions. Once the AP has established a connection with its management platform, the BLE radio state is
updated to match what's configured there. This state is maintained if the AP is power-cycled or rebooted.
Console Port Default State
When the Access Point is in factory default state the console interface (both physical port and BLE) is enabled
with default credentials (username is "admin" and password is the serial number of the unit). Once the AP has
established a connection with its management platform, the console port state (enabled/disabled) and access
credentials are updated to match what's configured there. State and credentials are maintained if the AP is
power-cycled or rebooted.
USB Host Interface Default State
When the Access Point is in factory default state the USB host interface is powered and enabled, assuming the
AP is not in a restricted power mode. On some AP models the USB port may be disabled when a POE source with
insufficient power budget is used. Once the AP has established a connection with its management platform, the
USB host interface state is updated to match what's configured there. This state is maintained if the AP is power-
cycled or rebooted.

Regulatory Model Number

The following regulatory model numbers (RMN) apply to the 500 Series:
AP-504 RMN: APIN0504

AP-505/AP-505S RMN: APIN0505


Safety and Regulatory Compliance

RF Radiation Exposure Statement: This equipment complies with RF radiation exposure limits. This
!
equipment should be installed and operated with a minimum distance of 13.78 inches (35cm) between the
radiator and your body for 2.4 GHz and 5 GHz operations. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
Aruba 500 Series Campus Access Points
| Installation Guide
9