Table of Contents
Advertisement
3.
Controls and Connectors
The diagrams on the following pages illustrate the external controls, indicators, and
connectors for the Kreativ Mach 5.0 and Mach 5.0 PLUS instruments.
In both the Mach 5.0 and the Mach 5.0 PLUS, the handpiece hose connects to a
connector located under the Control Module.
The Control Module is removable from the front of the Mach 5.0 and the Mach 5.0
PLUS and can be attached to the Dental unit, as follows:
1. The Control Module is held to the front of the instrument by spring tension on the
interconnecting cable. With the handpiece mounted in the cradle on top of the
Control Module, the hose and the provided extension cable allow the Control
Module to be remotely located up to 10 feet from the main unit. The connector to
the air supply is located on the rear of the instrument.
2. A mounting plate with clamp is supplied with the Mach 5.0 and the Mach 5.0
PLUS, to be mounted on the dental unit.
3. The Control Module will attach to the mounting plate for use at the dental unit,
remotely from the main instrument.
Item Descriptions
Refer to the Drawings in this section for the following items.
(1) On/Off Power Switch: turns power on or off to the entire instrument
(2) Power Cord Connector: connection point for the power cord.
(3) Fuse Box: the location of the instrument fuses. Always replace with the same
(4) Pneumatic Footswitch Connector:
(5) Electric Footswitch Connector: connection point for the electrical foot-switch
type of fuse with the same rating, indicated in Chapter 1.
pneumatic footswitch.
Page 11
connection point for the dental chair
990008 Rev. H
Chapter
3
Advertisement
Table of Contents
