Available Literature; Avoid Unintended Start - Danfoss VLT Micro FC 51 Quick Manual

1 Quick Guide
1.2 Introduction
1

1.2.1 Available Literature

This quick guide contains the basic information necessary for installing and running the drive.
If more information is needed, the literature below can be downloaded from:
http: //www.danfoss.com/BusinessAreas/DrivesSolutions/Documentations
VLT Micro Drive FC 51 Operating Instructions
VLT Micro Drive FC 51 Quick Guide
VLT Micro Drive FC 51 Programming Guide
FC 51 LCP Mounting Instruction
FC 51 De-coupling Plate Mounting Instruction
FC 51 Remote Mounting Kit Mounting Instruction
FC 51 DIN Rail Kit Mounting Instruction
FC 51 IP21 Kit Mounting Instruction
FC 51 Nema1 Kit Mounting Instruction
X = Revision Number, Y = Language code
1.2.2 Approvals
1.2.3 IT Mains
IT Mains
Installation on isolated mains source, i.e. IT mains.
Max. supply voltage allowed when connected to mains: 440 V.
As an option, Danfoss offers recommended line filters for improved harmonics performance.

1.2.4 Avoid unintended Start

While the frequency converter is connected to mains, the motor can be started/stopped using digital commands, bus
commands, references or via the Local Control Panel.
• Disconnect the frequency converter from mains whenever personal safety considerations make it necessary
to avoid unintended start of any motors.
• To avoid unintended start, always activate the [OFF] key before changing parameters.
2
Title
®
MG.02.B5.02 - VLT is a registered Danfoss trademark
Quick Guide for VLT Micro FC 51
Literature no.
MG.02.AX.YY
MG.02.BX.YY
MG.02.CX.YY
MI.02.AX.YY
MI.02.BX.YY
MI.02.CX.YY
MI.02.DX.YY
MI.02.EX.YY
MI.02.FX.YY