F&F EPP-618 Manual page 7

Programming the operating function
1. Press and hold the + button for approximately 5 s.
2. The display will show the currently set operating function; fac-
tory default is ��.
3. If the function is not changed, confirm with the ���� button.
4. If the function is to be changed, use the + or – buttons to set
the given function and confirm it with the ���� button.
5. Then, depending on which function has been selected, set the
value of Hi or Lo current, and each confirming the value with
the ���� button.
6. Next, set the the t
ting with the ���� button.
7. After saving the last value the relay will automatically exit the
function setting mode.
and t
values, also confirming each set-
ON OFF
- 7 -