Troubleshooting - Bissell CROSSWAVE X7 CORDLESS 2832F Manual

Troubleshooting

Below are some of the issues you may run into. If you don't see the
issue you're experiencing below, visit global.BISSELL.com.
Machine Issues
Problem Possible Cause
Brush roll window is not latched.
Debris channel in foot is clogged.
Streaking or
loss of suction
Filter is clogged by debris and/
power
or is wet.
Brush roll is wet and dirty.
Clean water tank is empty.
Clean water tank is not seated
properly.
No spray
Brush roll window is not latched.
Not holding trigger to spray
solution.
Clean water tank or lid is
damaged.
Leaking
Dirty water tank is damaged.
Dirty water tank is full.
Machine is Charging contacts on the 3-in-1
not charging Docking Station are dirty.
Remedies
Reinstall brush roll window.
Clean the channel with a paper towel.
Remove debris clogging the filter screen, then
clean and dry the filter.
Clean and dry the brush roll.
Refill tank. Follow steps on page 7.
Remove and reseat tank.
Reinstall brush roll window.
Hold solution spray trigger continuously
while using the machine.
Remove tank from machine and inspect for
damage on tank and/or lid. If damage is
found, contact us.
Remove tank from the machine and inspect
for damage. If damage is found, contact us.
Empty tank.
Use a cloth to wipe the gold charging contacts
on the dock. If issue persists, contact us.
global.BISSELL.com 13