Table of Contents
Advertisement
Troubleshooting
(continued)
Error Codes
Problem
Error and fan error
indicators on digital display
are blinking.
Dirty water tank full
indicator on digital display
blinks 4 times, then turns
solid.
Dirty water tank full
indicator on digital display
blinks four times, then turns
solid. Error indicator is
blinking.
Clean water tank indicator
on digital display blinks
then turns solid. Foot light
blinks blue 4 times.
Brush roll window LED
is blinking white, error
indicator is blinking.
Brush roll window LED is
blinking white and blue.
Battery indicator on digital
display shows continuous
blinking of 1 LED light
Note: Any other servicing should be performed by an authorized service representative.
14 global.BISSELL.com
Possible Cause
Air path is clogged.
Dirty water tank
is full.
Dirty water tank is
not seated properly.
Clean water tank is
empty.
Clean water tank is
not seated properly.
Brush roll is
obstructed.
Brush window lens
is not attached.
Battery is too low
to run the Clean
Out Cycle.
Remedies
Check the suction hose for
clogs. Perform standard after-
cleaning care maintenance.
See pages 11-12.
Remove and empty tank.
Thoroughly clean tank and
sensors. Place tank back into
the machine.
Reseat tank.
Refill tank. Follow steps on
page 7.
Remove and reseat tank.
Remove brush window lens
and brush roll to clean hair
and debris off of brush, brush
ends and brush gear.
Remove and reinstall the lens
until it 'clicks' into place.
Charge the machine for 30
minutes prior to running.
Advertisement
Table of Contents
