Everybot THREE SPIN TS300 User Manual page 8

Battery Charging
• Do not use any adapter other than the genuine adapter included.
• Please install the charging station on a flat surface.
• Use the product after fully charging it.
Caution
• When charging, empty all water in the water tank.
Charging time:
Approx. ��� minutes (��� minutes when fully discharged)
Operation time:
Approx. ��� minutes when cleaning with wet mop pads
Approx. ��� minutes when cleaning with dry mop pads
(Times may vary depending on the floor environment.)
• This product uses ���-���V~
Caution
1 Connect the power
adapter to the charging
station.
Connect the power adapter to
•
the adapter jack on the bottom
of the charging station.
Wrap the cables around the cable
•
fixing hook to organize them.
Connect the power adapter to
•
an electrical outlet.
8
as the rated voltage.
2 Mount the main unit
on the charging station
and start charging.
When the main unit is mounted
•
on the charging station, charging
will start with a "beep" sound.
The charging points of the main
•
unit and the charging station
must be plugged in to charge
normally.
Sufficient: ��% or more
Moderate: ��-��%
Low: Less than ��%
3 Check the charging
status.
Battery level indicator will
•
blink and turn on sequentially
as charging progresses.
When charging is complete,
•
all LED lights will be turned off.