Everybot THREE SPIN TS300 User Manual page 2

Quick Guide
Battery Charging
• Connect the power adapter to the
adapter jack on the bottom of the
charging station.
• Connect the power adapter to an
electrical outlet.
Before Cleaning
• Wet mop pads in water and
wring them out.
• Open the water tank cap and
fill it with water up to the mouth
of the water tank.
2
• When the main unit is mounted on
the charging station,charging will
start with a "beep" sound.
• Attach the mop pads to the
rotating plate by aligning the
holes with the center of the plates.
• Turn the water tank cap clockwise
to close it.
Sufficient: ��% or more
Moderate: ��-��%
Low: Less than ��%
• Check the charging status through
the LED indicator on the main unit.
• LED turns off when charging is
complete.
• Detach the water tank by pressing
the water tank release button on
the top of the main unit.
• After fitting the fixing rib of the water
tank into the groove of the main unit,
press the water tank down to assemble.