Everybot THREE SPIN TS300 User Manual page 13

Automatic Cleaning
Efficiently cleans the entire
space in basic cleaning mode.
Cleans automatically until
the battery is low.
Edge Cleaning
Moves along the wall and
concentrates on cleaning corners.
After cleaning corners for ��
minutes, switches to automatic
cleaning mode.
Residual water removal
By removing the remaining water from the machine, it maintains the hygiene of the product.
After cleaning in water supply mode, press the "Remove residual water" button on the remote control
to remove the water from the main unit.
After cleaning is complete, remove the water tank or empty the water.
1.
Make sure that the mop is attached to prevent spilling the water.
2.
Press the "Remove residual water" button on the remote control while the main unit is properly placed on the floor.
3.
The water level indicator will blink and remove residual water.
4.
After about �� seconds, when the water level indicator stops blinking, the residual water removal is complete.
5.
• Please use the residual water removal function regularly as the product may develop a bad odor
if this function is not used for an extended period.
• After using the residual water removal function, please wipe off a small amount of water that
Caution
may remain on the floor.
Intensive Cleaning
Cleans thoroughly by repeating
short straight lines and
���-degree rotations.
Y Cleaning
Moves back and forth in Y-shaped
patterns and effectively cleans
the floor.
Focused Cleaning
Cleans the space around the
product in detail.
��-min Cleaning
Stops after automatically cleaning
for �� minutes; great for cleaning
rooms.
50
min
13