Everybot THREE SPIN TS300 User Manual page 12

Using the Remote Control
How to Insert Batteries
➀ Remove the remote control cover.
➁ Insert the batteries as shown in
the picture.
➂ Close the remote control cover
by sliding it until it clicks.
• The maximum distance that the remote control signal can be received is �m,
Note
• The remote control does not work while charging the product.
Starts automatic cleaning or
stops cleaning operation.
Intensive Cleaning
Intensively cleans with straight
and rotating motions.
Moves back and forth in Y-shaped
patterns and cleans the floor.
Controls the amount of water
supplied to mop pads.
• The water tank supplies a constant amount of water to mop pads through electronic control.
• The water supply level can be adjusted with the remote control. Each time the button
Note
• You can check the selected level through the water level indicator on the main unit.
12
and there may be restrictions on signal reception if there are obstacles nearby.
Start/Stop
Y Cleaning
Water Control
is pressed, it instructs the tank in the following order : cut off water, Level �, and Level �.
Water Level �: Recommended for cleaning tough dirt or dust buildup;
Water Level �: Recommended for floors made of wood (plywood, solid wood,
Water cut off (dry mop): Recommended for sticky or wet floors due to high
Intensive Edge
Focus
Y-mode ��min
Drain Water
Water Control
mop pads are moistened sufficiently during cleaning.
engineered wood, etc.) and low level of dust buildup.
humidity during the rainy season.
Direction Control
Cleans the desired space in
your own pattern.
Focused Cleaning
Intensively cleans a small
surrounding space.
Edge Cleaning
Cleans the floor along walls
and corners.
Residual Water Removal
Removes remaining water
inside the main unit.
��-min Mode
Stops after cleaning for
�� minutes.