Dehumidification Mode - Sharp CV-P09FR Installation And Operation Manual

DEHUMIDIFICATION MODE

In this mode, the air conditioner dehumidifies the room.
"OPEN position"
Hose
CAUTION
The unit generates heat during dehumidification mode and the room temperature will rise.
Install the exhaust hose if you do not want the room temperature to rise. This will help to
slightly drop the room temperature, but dehumidification performance will become less
effective than when operating without the exhaust hose.
1
Remove the exhaust hose (See Page 8)
2
Turn the drainage nozzle to the OPEN
position.
Drainage nozzle
3
Pull the stopcock out from the drainage
Stopcock
nozzle.
• When the stopcock is removed, a small amount
• Always perform this procedure with the unit
4
Insert the hose clamp into a standard
commercially-available hose (12.7 mm in-
Hose clamp
ner diameter, 16.7 mm outer diameter)
5
Attach the hose to the drainage nozzle,
and secure it with the hose clamp.
• Depending on room condition, approximately
• Set the hose sloping downwards for easier
6
Press the MODE button to select DEHU-
MIDIFICATION mode.
7
7
Press the ON/OFF button to start opera-
tion.
• The red OPERATION lamp (
6
• The temperature cannot be set.
• The fan speed is preset to AUTO and cannot
TO TURN OFF
Press the ON/OFF button again.
• The red OPERATION lamp (
off.
E-10
of water may be discharged from the drainage
nozzle.
turned off. Drain water will spout out if
attempted during operation.
28 liters of water per day (24 hours) will be
dehumidified.
Prepare some kind of bucket of appropriate
size to collect drain water, or take some appro-
priate measure to drain the water outside of the
room, so that drain water will not overflow or
soak your room.
drainage. Moreover, do not bend the hose at
any point, nor allow the end to be submerged
in water.
COOL DEHUM
light.
be changed.
FAN VENT
)on the unit will
)on the unit will turn