Table of Contents
Advertisement
Pre-Cat
Probe
EMS also offers a pop nut insert tool kit (Fig.4) for the pre-cat probe w/ a 1/4"-20
threaded end. The kit includes the pop nut insert tool, 1/4-20 mandrel, box of 40 nuts, 50
pc's 1/4-20x3/8" stainless steel SHCS, 25/64" drill bit The EMS EVAP probe,( small
engine) (Fig. 5) is 3/16" O.D. and very flexable to help find radiator or exhaust leaks in
tight spaces.
Figure 1
Figure 4
Diagnostic Accessories
Water trap
Assembly
Figure 2
The EMS water trap assembly
(Fig. 1) is essencial for road
testing, Dyno use, Diesel testing,
motor cycle testing, and two
cycle fuel testing. This accessory
will prolong the analyzer life by
Post-Cat
pulling more moisture out of the
Probe
sample gas.
The Y-Valve assembly (Fig. 2)
was designed for pre-catalytic
converter testing. With the real
benefit being able to hook up
Y-Valve
both pre & post cat sample hose
Assembly
& probes. And swich between
both readings at the analyzer,
which saves you time. Also check
back pressure on the pre-cat side
at the analyzer with our inline
EVAP
pressure gauge (Fig.3)
Probe
20
Figure 3
Figure 5
Advertisement
Table of Contents
