Welch Allyn CP 100 Service Manual page 32

26 Overview
Function
MMCSDTEST.EXE:
NORMANDY.EXE:
NORMTESTER.EXE
PPPTEST.EXE
PPPTEST2.EXE
Description
Used to test the SD memory card write/read function of the unit. Can also be used to test an SD memory card
for problems.
GO: Starts the SD memory card test by pressing "G"
STOP: Stops the SD memory card test by pressing "S"
ERASE ALL: Erases all files written by this tester by pressing "E"
Card Present: If checked the unit detects the SD memory card inserted.
Write Protect: If checked the unit detects the lock is enabled on the SD memory card.
Pulse: Flashes when test is active
Note: Once the test is started it runs continuously. Press the "S" key to stop the test.
Used to return to the ECG program.
Strictly used for development purposes.
Strictly used for development purposes.
Used to see battery and charger status/state. There are a number of selections on this screen. Listed below
are the most commonly used functions. To activate a selection press the letter that coincides with the
selection.
Real-time: Activates a real-time monitoring of the readings from the battery circuit.
Battery Voltage: Unplugged from AC this reflects the Voltage of the battery in millivolts; plugged into
AC this reflects the charge voltage in millivolts.
Fast charge = 6800 – 7300
Trickle charge = 6300 – 6800
Battery Current: Indicates charge current in mA when charger is on.
Charger State: Indicates if charge circuit is on or off
Charge State: Indicates if the Fast Charge is on or off
Fast Charge On: Turns fast charge on. If battery is fully charged the sensing circuit can work against
you. It only changes the reading for a brief second before switching back.
Fast Charge Off: Turns fast charge off.
Charger On: Turns charger on when plugged into AC.
Charger Off: Turns charger off.
Welch Allyn CP 100 and CP 200 Electrocardiograph