ICP DAS USA UA-5200 Series Quick Start page 2

1.
Preparations for Devices
Prepare one UA-5200 (Ex: UA-5231), and the following:
1. PC/NB: Can connect to the network and set the network
2. Ethernet Hub or Switch (Ex: NS-205A)
3. Power Supply: +12 ~ +48 VDC (Ex: MDR-60-24)
2.
Hardware Connection
Connect the UA-5200 with the RJ-45 Ethernet port to an
Ethernet hub/switch and PC. You can also link directly the
UA-5200 to PC with an Ethernet cable.
After power is connected, please【wait 1 minute】for UA-5200
start-up procedure. When the "RUN/PWR" light starts flashing,
it represents the boot is complete.
Hub/Switch
Ethernet
Cable
PWR
Ethernet
Cable
P.GND
-V
+V
Power Supply
(12 ~ 48 VDC)
P.2