Canon BJC-50 User Manual page 67

Remove the new battery pack from its packaging.
6.
Insert the battery pack into the slot at a slight angle to match its
7.
connector slots to the prongs inside the left corner of the battery
pack slot.
8. Push in the right side of the battery pack to lock it in place.
Close the front cover.
9.
10. If you have just installed a new battery pack, you must allow it to charge before
you can use it. Just leave the AC adapter connected to the printer and the power
outlet. The battery pack will charge while the printer is switched off or on.
About six hours (maximum) is required for the battery pack to fully charge.
If you have replace an exhausted battery pack, dispose of the battery pack according to
the regulations in your country. For details, contact your Canon Authorised Dealer or
Canon Representative.
65
65