Installing The Battery Pack - Canon BJC-50 User Manual

.
Print head flushing. Press and hold down the RESUME button for over two seconds until the
printer beeps three times then release to start print head flushing. The POWER lamp flashes
during print head flushing. (8O)
CHARGE/ERROR lamp
When the printer is off and the AC adapter is connected to the printer and plugged into the power mains,
the CHARGE/ERROR lamp lights and stays on while the battery pack inside the printer is recharging.
After the battery pack is fully charged, this lamp will go off.
When the printer is on, the
Remove the cause of the error then press
switch on the printer, the empty cartridge holder will move to the centre. The
lamp will flash once and the printer will beep to remind you to install a BJ Cartridge.

Installing the battery pack

Follow this procedure to install the battery pack in the printer.
Install only a Canon Li-Ion Battery LB-50 battery pack. You must install the battery pack and leave it
installed in the printer, even if you intend to use the printer only with the AC adapter. If the battery pack is
not installed when you switch on the printer, the CHARGE/ERROR lamp will light orange and the printer
will beep six times.
1.
Open the front cover.
2. If you are installing a new battery pack, remove the battery pack from its package.
.
CHARGE/ERROR
lamp lights or flashes orange when an error occurs.
RESUME
to resume normal operation. The first time you
19
CHARGE/ERROR
19