Table of Contents
Advertisement
Using PT-H99 for data communication
You can connect a personal computer to your PT-H99 for digital data communication. To
do this, you need an optional data cable or an optional PCT data communication card.
To connect PT-H99 and PC:
Data communication
connector
USB slot
or
PCT data
communication card
When connected to a personal computer,
the display appears in the standby mode.
Depending on the type of personal computer,
the above display may not appear at once.
84
*PT-H99(AH)_05E/02
84-85
PCMCIA slot
To start data communication:
See the manual attached to the other
equipment for how to send/receive data.
Hints:
• The phone number dialed for
communication is not memorized as a
redial number.
• Communication may be disconnected
when you use PT-H99 where the signal
is faint or where you are moving.
• Leaving the PCT data communication
card connected to PT-H99 consumes
the battery power. Disconnect the cable
when you finish data communication.
• Even when the display shows data
being terminated, PT-H99 cannot
answer. Use the personal computer
for answering.
• The PT-H99 speaker does not function
during data communication.
• Do not use the Transceiver mode for
data
communication.
If
the
communication isn't good in the Public
and Private mode or Public and
Transceiver mode, try with the Public
mode.
01.10.11, 9:15 PM
85
Advertisement
Table of Contents
