Page 1
Installation and operating instructions ELECTRIC FRYERS FOR PROFESSIONAL USE F18-94ETX F2/18-98ETX F25-94ETX F2/25-98ETX F13T-94ETX F2/13T-98ETX F2/8-94ETX F2/8T-94ETX Model LIBR.ISTR.FX 90E POT Code 563016404 Review 1 Edition date 17/01/2020 Language English LOTUS S.p.A. Via Calmaor, 46 31020 San Vendemiano +39 0438 778020...
Contents Contents INTRODUCTION ......................... Installation drawing ........................Components..........................Fixing feet ............................ Example installation of the appliance................... GENERAL INFORMATION......................Declaration of compliance......................User information, RAEE Directive on waste electrical and electronic equipment ......Technical data table ........................INSTALLATION........................... Delivery checks ..........................Removing the packaging ......................
INTRODUCTION Components FIG. B (ROTARY RESISTANCE) 1 O-rings 2 Rotary heating element Caution These fryers are equipped with an acoustic-visual alarm, which is activated when the safety thermostat trips (oil overtemperature). To interrupt the alarm, turn the control knob to zero (but the system remains operational until the problem that caused the intervention is resolved) ...
Page 6
INTRODUCTION WIRING DIAGRAM (A) 1 Cicada 2 Switch 3 Microswitch 4 Power supply terminal board 5 Heating element 6 Resistance voltage drop 7 White indicator light 8 Red indicator light 9 Green indicator light 10 Contactor 11 Thermostat 12 Safety thermostat Translation of the original instructions...
Page 7
INTRODUCTION Electrical technical data table MODEL WIRING DIAGRAMS WIRING DIAGRAMS F18-94ETX F2/18-98ETX A + A F25-94ETX F2/25-98ETX F13T-94ETX F2/13T-98ETX F2/8-94ETX A + A F2/8T-94ETX A + A PREDISPOSITION 440V~3 Translation of the original instructions...
GENERAL INFORMATION 2 GENERAL INFORMATION Declaration of compliance The manufacturer declares that the appliances comply with the requirements of the regulation GAR 2016/426 for the gas part and directive 2014/30/EU,2014/35/EU for the electrical part. Installation must be performed in compliance with current regulations, especially with regard to ventilation of the premises and the exhaust gas evacuation system.
Technical data table Electrical technical data table F S90EX MAXIMUM MAXIMUM INPUT Silicon POWER MODEL DIMENSIONS POWER SUPPLY POWER (kW) SUPPLY CABLE F18-94ETX 40x90x90h 400V~3 50/60 Hz 15,9 23,04 4 x 4 mm² F18-94ETX 40x90x90h 440V~3 60 Hz 15,9 20,86 4 x 2,5 mm²...
INSTALLATION 3 INSTALLATION Delivery checks On delivery, it is important to check the following: · External conditions of the packaging · The general status of the equipment · The conformity of the model with the information in the technical data plate and the instruction manual ·...
Page 13
INSTALLATION Warning Installation operations, any conversion to other types of gas and start-up must only be performed by qualified personnel, in accordance with current regulations. Gas systems, electrical connections and premises where the appliances are installed must comply with current regulations in the country of installation;...
INSTRUCTIONS FOR USE 4 INSTRUCTIONS FOR USE General information This appliance must only be used for its expressly intended purpose for cooking or heating food. Any other use is considered improper. The appliance is also intended for industrial use and must only be used by personnel trained for use and aware of the risks that the hot element entails.
INSTRUCTIONS FOR USE If using the fryer with products other than oil (lard, for example) that have considerable thermal inertia, it is necessary to set the thermostat to a low value (e.g. 110°C) during the first cycle (not starting cold). The thermostat can be set to the maximum only after the entire mass has melted ...
MAINTENANCE 5 MAINTENANCE Routine When using the appliance over time, it is essential to perform regular maintenance to ensure safe operation. We therefore recommend stipulating a service contract. Caution Maintenance must only be performed by specialist personnel in compliance with current ...
MAINTENANCE Spare parts It is possible to replace parts such as the valve, the piezoelectric or the ignition control unit (depending on the type of appliance) or the gas pipes easily and quickly. To replace such parts, proceed as follows: ...
CLEANING 6 CLEANING Routine cleaning Caution The use of flammable fluids to clean the appliance is forbidden To ensure hygiene and the durability of the appliance, perform external cleaning on a regular basis, taking care not to damage the cables and the electrical connections. Before starting cleaning, disconnect the appliance from the power supply.