Carrier Disassembly And Assembly - Ramsey Electronics WILDCAT 130K Operating, Service And Maintenance Manual

DISASSEMBLY OF INPUT CARRIER
Carrier assemblies may be purchased as a complete assembly (see pg. 23) or parts may be
purchased individually (see parts list below). If purchasing individual parts, it will be necessary to
disassemble the input gear carrier as outlined below.
1. Carefully drive roll pin #104 into carrier pin #103 so that it is captured within carrier pin #103
but not touching the opposite side of the input carrier #106.
2. Tap carrier pin #103 to remove it from the input carrier #106.
3. Slide the planet gear #101and the (2) thrust washers #102 from the carrier #106. Bearings
#105 may then be pressed out.
4. Remove the roll pin #104 from the carrier pin #106.
5. Repeat this process for the two remaining gears in the carrier.
105
102
ITEM # QTY PART #
101 3 334225
102 6 518070
103 3 470130
104 3 470103
105 3 402140
106 1 317026
106
101
103
DESCRIPTION
GEAR-PLANET
THRUST WASHER
PIN-CARRIER
ROLL PIN 1/4 DIA X 1 1/4 LG
ROLLER
CARRIER-INPUT
14
102
104