Ramsey Electronics WILDCAT 130K Operating, Service And Maintenance Manual page 19

ASSEMBLY OF INTERMEDIATE CARRIER
Note: Item Numbers refer to Carrier parts list on page 16
1. Place output carrier #201 on flat clean surface.
2. Press one set of needle bearings #206 into gear #202. Turn gear #202 over.
3. Install spacer #207, and the next needle bearing #206.
4. Slide the gear #202 into position in the output carrier #201.
5. Place thrust washer #203 on top of gear #202. Insert carrier pin #204 into carrier #201
6. Turn output carrier #201 on its side so that the gear #202 is on top.
7. Insert a thrust washer between gear #202 and output carrier #201. Completely insert carrier
pin #204 into carrier #201 using care to align the roll pin hole in carrier pin #204 with the roll
pin hole in the output carrier #201.
8. Drive roll pin #205 into output carrier #201 until roll pin #205 is flush with surface of the output
carrier #201.
9. Repeat steps 1-8 to install the two remaining gears into the output carrier.
17