Disassembly Of Carrier Assembly - Ramsey Electronics WILDCAT 80,000 LB Series Operating, Service And Maintenance Manual

DISASSEMBLY OF CARRIER ASSEMBLY

Carrier assemblies may be purchased as a complete assembly (see pg. 19) or parts may be
purchased individually (see pg 16). If purchasing individual parts, it will be necessary to
disassemble the gear carrier as outlined below. Disassembly/ assembly of carriers utilizes the
same process for input carrier assembly #4, intermediate carrier assembly #3, and output
carrier assembly #2. Detail shown below is for intermediate carrier assembly#3. Please see
page 16 for detailed parts list and drawings of individual carriers.
1. Carefully drive roll pin #112 into carrier pin #111 so that it is captured within carrier pin #111
but not touching the opposite side of the intermediate carrier #102.
2. Tap carrier pin #111 to remove it from the intermediate carrier #102.
3. Place a plastic pail in a position to catch bearings #110, spacer #108 and washers #115, then
slide the gear #105 from the carrier assembly #102.
4. Remove the roll pin #112 from the carrier pin #111.
5. Repeat this process for the two remaining gears in the carrier.
102
112
115
INTERMEDIATE CARRIER
14
105
110
108
110
115
111
OM-914207-0211-D