Table of Contents
Advertisement
HYDRAULIC SYSTEM REQUIREMENTS
Refer to the performance charts, below, to properly match your hydraulic system to winch performance.
The charts consist of:
(1) Line pull (lb.) first layer vs. working pressure (PSI) and (2) line speed, first layer (FPM) vs. gallons per
minute (GPM).
Performance based on a motor displacement of 7.0 cubic inches/rev with 60 GPM
maximum flow rate. Motor has (2) 1"-12 SAE straight thread o-ring ports.
Note: A motor spool (open center) directional control valve is required for brake operation.
MOTOR CASE DRAIN
MOTOR 2 SPEED
PERFORMANCE CHARTS
BASED ON 7.0 CU IN/REV MOTOR
LOW PRESSURE LINE
BRAKE
SAE -16
1" TUBING SIZE
12 VDC
SHIFT SOLENOID
PORT #5
PORT#3
COUNTER BALANCE
VALVE
COUNTER BALANCE/SPEED SELECTOR BLOCK
DIRECT LINE TO TANK
HIGH PRESSURE LINE
PAYOUT
PORT #1
PAYIN
SAE -16
1" TUBING SIZE
BAND BRAKE
CLUTCH
AIR CONNECTIONS
2
CUSTOMER
SUPPLIED
PUMP
SYSTEM
RELIEF
3 POSITION
4 WAY VALVE
Advertisement
Table of Contents
