Table of Contents
Advertisement
5. Remove motor #53 from winch by first disconnecting hydraulic lines (see page 17), solenoid
wires, and then remove (4) bolts #36. O-ring #55 may now be removed.
6. Remove brake cover #50 by removing (4) bolts #35. The cover is spring loaded, use care
when removing. Remove o-ring #54 then springs #69 may be removed; residual oil may be
present in the brake housing.
7. Remove piston #13 including o-rings and backup rings #56, #57, #58, and #59 by using a
momentary puff of compressed air into the brake port located on top of the end bearing.
Capture the piston by placing a shop rag over the opening prior to using air.
8. Remove the sprag brake hub assembly #5, (7) stator plates #14, (6) disc brakes #15, and the
spacer #25. The sprag brake hub assembly #5 is not a serviceable part, if damaged a
replacement assembly should be ordered.
50
35
55
53
36
57
56
13
58
59
69
54
74
25
5
15
14
7
Advertisement
Table of Contents
