Table of Contents
Advertisement
DISASSEMBLY OF INTERMEDIATE CARRIER
Carrier assemblies may be purchased as a complete assembly (see pg. 23) or parts may be
purchased individually (see below). If purchasing individual parts, it will be necessary to
disassemble the gear carrier as outlined below.
1. Carefully drive roll pin #205 into carrier pin #204 so that it is captured within carrier pin #204
but not touching the opposite side of the output carrier #201.
2. Tap carrier pin #204 to remove it from the output carrier #201.
3. Slide the planet gear #201and the (2) thrust washers #202 from the carrier #206. Bearings
#205 may then be pressed out.
4. Remove the roll pin #205 from the carrier pin #204.
5. Repeat steps 1-4 for remaining gears.
302
303
ITEM
QTY
PART NO
201
1
317025
202
3
334224
203
6
518073
204
3
470129
205
3
470103
206
6
402143
207
3
362316
307
306
304
DESCRIPTION
OUTPUT CARRIER
PLANET GEAR
THRUST WASHER
CARRIER PIN
ROLL PIN 1/4 DIA X 1 1/4 LG
BEARING-NEEDLE ROLLER
SPACER
16
303
306
301
305
Advertisement
Table of Contents
