Table of Contents
Advertisement
19. By removing snap ring #67 and ball bearing #30, the input shaft #23 may be removed.
20. To remove the motor end bearing #20, support drum #16 with a nylon strap or chain and hoist.
Lift on the drum to tension the strap. Remove (6) bolts #39 and (6) nuts #42 attaching the end
bearing to the mounting angles #7 and #8. The motor end bearing #20 will be supported on the
output shaft end and may be slid off using a nylon strap and hoist to lift it.
23
30
67
39
20
42
11
16
8
7
39
Advertisement
Table of Contents
