Table of Contents
Advertisement
● Caution / Using Use of the Machine
▶Trained oprerater has to handle the machine only.
▶The machine has to use for sewing on the material only.
▶Always turn the power off (of the machine) for avoiding the risk of accidents or when it is
not used injury. Also, in case of following, turn the power off.
@@－When threading the needle
@@－When replacing the bobbin or the needle
@@－When the machine unuse during long periods.
@@－In case of using the clutch motor, the motor will be rotated for a moment due to its inertia
even the power was turn off. Wait until the motor to stop completely.
▶When using a table with casters, fix the casters.
▶Check the rotating direction of the motor after completing the installation of the machine. To
do so, while the needle bar locate on the lowest position by pulley rotating manually, turn
the power on. And then check the pulley out. (The pulley must rotate in the
counterclockwise direction when it is viewed from the side of pulley.)
▶In case of operating the machine or turning its power on, keep your hands away from the
needle.
▶Do not insert your fingers into the thread take-up cover when the machine is operating.
▶Turn the power off before removing the V-belt or tilting the machine.
▶Install all safety device provided by the manufacturer before operating the machine.
It causres of injury.
▶Never touch any pant of the machine while it is in motion, nor overly press any part of the
machine in order to avoid the risk of injury or the demage of the machine.
▶Because of the heavy weight of the machine, a minimum of two person must be involved in titling
the machine back or return.
▶If any ilregular noise or smell is detected, or any malfunctioning occurs during sewing, turn
the power off of the machine immediately. And then contract the Sunstar dealer.
▶For any other problems occurring during the operation of the machine, contact the Sunstar
dealer or the head quntor.
6
Advertisement
Table of Contents
