Troubleshooting - Parkside PWDS 920 B2 Operation And Safety Notes

˜ Troubleshooting
Problem
Product does not work . Power supply interrupted .
Product does not
operate with full
power .
Poor performance .
Extensive dust
formation .
Possible cause
Power cord or power plug
defective .
Carbon brushes worn out .
34 ] [
Other electrical defect .
Extension cord too long and/or
cross-section too small .
Voltage of the power supply
(e .g . generator) too low .
Sandpaper worn out .
Sanding pad worn out .
[ 2 ]
Brush edge worn out .
[ 7 ]
External dust extraction unit not
connected or switched off .
Solution
Check the socket-outlet by connecting
another electric appliance .
Have the product repaired by a
15 ] [
qualified specialist .
Replace the carbon brushes
(see "Main tenance") .
Have the product repaired by a
qualified specialist .
Use an extension cord with
permissible length and/or adequate
cross-section .
Connect the product to an appropriate
power supply .
Replace the sandpaper .
Have the sanding pad replaced by a
qualified specialist .
Have the brush edge replaced by a
qualified specialist .
Connect or switch on external dust
extraction unit .
[ 34 ]
GB/IE/NI 23