Table of Contents
Advertisement
1. Have your gas supplier check all gas piping annually
for leaks or restrictions in gas lines.
2. The h h eater's s s urrounding a a rea s s hall b b e k k ept c c lear a a nd
free f f rom c c ombustible m m aterials, g g asoline, a a nd o o ther
flammable v v apors a a nd l l iquids.
3. Regulators can wear out and function improperly.
Have your gas supplier check the date codes on all
regulators installed and check delivery pressures to
the appliance to make sure that the regulator is
suitable for continued use.
4. Regulators must be periodically inspected to make
sure the regulator vents are not blocked. Debris,
insects, insect nests, snow, or ice on a regulator can
block vents and cause excess pressure at the
appliance.
5. For safety as well as for optimum performance at the
heater, it is necessary to keep the inside and the
outside of the heater free of dust, dir t or any
combustible material.
B B u u r r n n H H a a z z a a r r d d
■
Heater surfaces are extrememly hot for a period of
time after the heater has been shut down.
■
Allow the heater to cool before performing service,
maintenance, or cleaning.
■
Failure to follow this warning will result in burns
causing injury.
F F i i r r e e a a n n d d E E x x p p l l o o s s i i o o n n H H a a z z a a r r d d
■
Do not disassemble or attempt to repair any heater
components or gas train components.
■
All component parts must be replaced if defects are
found.
■
Failure to follow this warning will result in gas leaks
leading to fire or explosions, causing property
damage, injury, or death.
WARNING
WARNING
Maintenance Instructions
6. Immediately replace components which show signs of
rust or corrosion.
7.
If any warning or instruction labels, dataplates, etc.
become lost or hard to read, replace them
immediately. Do not operate the heater until you
have all instructions and can read and understand
them.
8. Check overall condition of heater for cracked or
damaged components, loose screws or bolts, etc.
Replace any suspect components.
9. Check all hose and tubing assemblies for cracks,
abrasions or ruptures. Replace any hoses that are
suspect.
10. Check the installation periodically during use to make
sure the hanging kit is level and securely tightened to
the crate. Also, ensure hanging rod is plumb.
11. Clean the heater and filter between building turns.
Refer to cleaning instructions in this manual.
Service Instructions
1. Close the fuel supply valve to the heater before
servicing unless it is necessary to have it open for
your service procedure.
2. For reassembly, reverse the respective service
procedure. Ensure gas connections are tightened
securely.
3. After servicing, start the heater to ensure proper
operation and check for gas leaks.
4. Clean the heater's orifice with compressed air or a
soft, dry rag. Do not use files, drills, broaches, etc. to
clean the orifice hole. Doing so will enlarge the hole,
causing combustion or ignition problems. Replace
the orifice if it cannot be cleaned properly.
GENERAL
12
Advertisement
Table of Contents
