Electrical Connection - Samson TROVIS 5757-3 Mounting And Operating Instructions

5.6 Electrical connection

NOTICE
!
Risk of actuator damage through opening
the actuator housing.
Î Do not open the actuator housing.
DANGER
!
Risk of fatal injury due to electric shock.
Î Upon installation of the electric cables,
you are required to observe the regula-
tions concerning low-voltage installations
according to DIN VDE 0100 as well as
the regulations of your local power sup-
plier.
Î Use a suitable voltage supply which
guarantees that no dangerous voltages
reach the device in normal operation or
in the event of a fault in the system or
any other system parts.
Î Only perform the electrical connection
after switching off the supply voltage.
Make sure the supply voltage cannot be
switched on again unintentionally.
The switching output (black wire) is live.
Î Do not touch the wire ends of the switch-
ing output.
Î Insulate the wire ends when the switching
output is not used.
EB 5757 EN
NOTICE
!
Risk of actuator damage due to incorrect
wiring of the inputs.
Î Wire the inputs range according to the
technical data (see the 'Design and prin-
ciple of operation' section).
Wiring
Î Connect the wiring as shown in Fig. 5-3
and Fig. 5-4.
Î Insulate any wires that are not used.
Installation
5-3