Table of Contents
Advertisement
SPT and MPT x3x series
Note
Responder function
Recovery
Caution
32
When deploying the II transponder, the two units must be
positioned in the same direction (referring to the top markings).
To activated this function, the transponder must be connected
directly to the HiPAP / HPR system via a cable.
• The responder function is automatically initiated by the
presence of a valid "Trigger" pulse. When you provide a
valid trigger pulse from the HiPAP / HPR system, the
responder will reply on the previously selected channel.
For the MPT 139/DTRspSx model:
• If a HPR 300 system is used, activate the ENABLE SSBL TP
function.
After recovery, wash the unit thoroughly in fresh water to
dissolve any salt deposits and clean off any sand or silt. If
available, an high pressure hose may be used.
→
Refer to "Handling" on page 143.
Aluminium transponder release:
It is very important that the release unit (if fitted) is
washed properly. Salt deposits, may prevent the
'
mechanical part
s mobility.
160780 / L
Advertisement
Table of Contents
