Table of Contents
Advertisement
RUSKA 2465A-754
Users Manual
Should it ever become necessary to replace the power fuses, the fuse holders are located
in the power-in receptacle on the side of the Motor Case Assembly (2465-15). These fuse
holders are located inside the cavity above the three power receptacle prongs.
1. Disconnect the power cord from the wall power receptacle and from the Piston
2. Use a small flat blade screwdriver to pry the voltage select/fuse holder compartment
3. Replace fuses only with the 3AG Slo-blo 1/4 Amp fuse (part #26-222). To replace
4. Close the compartment door, making sure that the correct voltage is showing through
5. If the correct voltage is not displayed through the window, pry open the door again.
6. Close the door until it snaps back into place.
5-12
Pressure Gauge's power-in receptacle.
door out from the power-in receptacle. Both the fuses should be checked and
replaced if necessary with fuses of the correct value depending on 115 VAC or
230 VAC local power supply conditions.
the fuse holders, simply push them back into the receptacle so that they snap back
into place.
the small window.
Remove the voltage select wheel, turn it to the correct value, and replace it within the
fuse compartment.
Advertisement
Table of Contents
