Maintenance; Service And Adjustments - Agri-Fab 45-0329 Owner's Manual

For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983

MAINTENANCE

CHECK FOR LOOSE FASTENERS
1. Before each use make a thorough visual check of the
spreader for any bolts and nuts which may have
loosened. Retighten any loose bolts and nuts.
CHECK FOR WORN OF DAMAGED PARTS
2. Check for worn or damaged parts before each use.
Repair or replace parts if necessary.
CHECK TIRE INFLATION
3. Check if tires are adequately inflated before each
use. Do not inflate beyond maximum recommended
pressure.
CAUTION: DO NOT inflate tires beyond
the maximum recommended pressure
printed on side of tire.
CLEANING
4. Rinse inside of hopper and exterior of spreader and
dry off before storing.
LUBRICATE (See figure 16)
5. Lightly apply automotive grease as needed to the
sprocket and gear.
6. Oil the nylon bushings on the vertical sprocket shaft
and on the axle at least once a year, or more often as
needed.
7. Oil right hand (idler) wheel bearing at least once a
year or more often as needed.
OIL
GREASE
FIGURE 16
ENGLISH
OIL
10
www.mymowerparts.com
STORAGE
1. Rinse inside of hopper and exterior of spreader and
dry off before storing.
2. Store in a clean, dry area.

SERVICE AND ADJUSTMENTS

1. If the axle, slotted gear and sprocket assembly is
disassembled, mark down the positions of the parts
as they are removed. The drive wheel and sprocket
positions in relation to the slotted gear determine
which direction the spreader plate will spin. Be sure
to reassemble them in their original positions. (Refer
to figure 4 on page 6.) Use shim washers (Ref. no. 21
on pages 20 and 21) as needed for minimum back-
lash. Add grease to gear and sprocket.
2. If the agitator hairpin becomes damaged or worn it
can be replaced. See figure 17.
SPROCKET
SHAFT
AGITATOR
HAIRPIN
FIGURE 17