Loewe Contur 2063 Operating Instructions Manual page 13

Adjusting sound
Line: "Sound via"
Select "Hi-fi system" if the TV sound is to be
transmitted over a Hi-fi system. The TV
loudspeakers are turned off. Use a cable to
connect the Hi-fi system to the "AUDIO OUT"
cinch sockets on the rear of the TV set.
Line: "Hi-fi volume"
if "Sound over Hi-fi system" has been selected.
Here you can adjust the volume of the Hi-fi
system using the TV remote control.
Line: "Volume"
You can adjust the loudspeaker volume using
the right/left arrows on the ring.
Line: "Loudspeaker sound"
Here you can select a sound. You can choose
between mono or stereo playback over the Hi-fi
system for stereo programmes. For two-sound
transmissions, you can select the main
language, Sound 1, or the foreign language,
Sound 2.
Line: "Headphone volume"
Use the right/left arrows on the ring to adjust
the headphone volume, independently of the
set loudspeaker volume.
Line: "Loudspeaker sound"
Here you can select a sound. You can choose
between mono or stereo playback for stereo
programmes. For two-sound transmissions, you
can select the main language, Sound 1, or the
foreign language, Sound 2. If the stereo
reception is weak, you can switch to mono.
Line: "Headphone sound"
When receiving a two-sound programme from
the cable network or from a roof-top aerial, you
can select Sound 1 or Sound 2 for the
headphones independently of the loudspeaker
sound.
This is not possible for stereo/mono or satellite
reception.
Line: "AV Output sound"
If a mono video recorder is connected to the
audio/video connection socket (AV1 or AV2) of
the TV set, you can select Sound 1 (main sound)
or Sound 2 (foreign language) when receiving a
two-sound programme. You should select
"Sound 1+2" for a stereo video recorder. When
playing back the recording, you can then select
the sound on the recorder.
Line: "AVC"
Use the right/left arrows on the ring to switch
the Automatic Volume Correction on and off. If
"AVC" is switched on, differences in volume
when changing from one channel to another
are reduced.
You can make additional adjustments in the
Sound menu under "other":
To select
menu line
Sound menu
Other ...
Maximum volume
Base widening
Treble
To adjust Bass
Balance
Line: "Max. volume"
You can limit the adjustable volume of the
loudspeakers. This will prevent children from
setting a volume that is too loud.
Use the right/left arrows on the ring to set a
maximum value for the volume.
Line: "Base widening"
Changing to "Base widening on" adds width
to the stereo sound.
Line: "Treble"
Use the right/left arrows on the ring to raise
(values 1 to 12) or lower (values –1 to –12)
treble sounds.
Line: "Bass"
Use the right/left arrows on the ring to raise or
lower (values 1 to 12 or values –1 to –12) bass
sounds.
Line: "Balance"
Use the right/left arrows on the ring to adjust
the balance so that the overall impression of
volume is the same on the right and the left.
50
Back
M
End
E
13