Toro 824 Operator's Manual
Hide thumbs
Also See for 824:
- Service manual (54 pages) ,
- Operator's manual (24 pages) ,
- Operator's manual (28 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Need help?
Do you have a question about the 824 and is the answer not in the manual?
Questions and answers
about power max snowthrower quick start guide function 2 picture B are the two cables running down from the top half of the handle on the engine side of the cross bar or on the operators side of the cross bar ?
The two cables on the Toro Power Max snowthrower part number 824 run down from the top half of the handle on the engine side of the cross bar.
This answer is automatically generated
information about power max snowthrower quick start guide ?
The quick start guide for the Toro Power Max 824 OE Snowthrower (Model No. 37793) includes the following steps:
1. Handle Installation:
- Remove tie straps from control rods.
- Remove axle pins and slide wheels outward about 1 inch (2.5 cm).
- Align and mount each handle side using capscrews and curved washers (concave side against the handle).
2. Auger and Traction Drive Control Installation:
- Install parts including flange locknuts, compression spring, worm gear, bracket, and carriage screw as specified.
3. Chute Control Rod Installation:
- Use flat washer, locknut, and key to secure the chute control rod.
4. Starting the Engine:
- Insert the key.
- Follow engine starting procedure (not fully detailed in the context).
This setup is intended for residential snow removal on paved surfaces only.
This answer is automatically generated