300 Installation
Connection procedure
WARNING! Obey the safety instructions. See chapter
page 13. If you ignore them, injury or death can occur.
1. Stop the drive and do the steps in section
before you start the work.
2. Make sure that the FSO electronics grounding screw is correctly tightened. See
section
Tightening torques
3. Make sure that the enclosure grounding screw is correctly tightened. Use T10
head. See section
2
3
on page 517.
Tightening torques
on page 517.
Safety instructions
Electrical safety precautions
on
on page
14
2
3