Care Recommendations - Sub-Zero PRO Series Use And Care Manual

Operation
Ice Maker Operation
To initiate ice production, touch on the freezer external
touch display. will be visible in the display. After initial
start-up, discard the first few batches of ice. The ice may
contain impurities from new plumbing connections.
Max ice increases ice production up to 30% for a 24-hour
period. Touch to activate max ice. will be visible in
the display.
If ice is not used regularly, it may fuse together. To avoid,
discard the ice and allow the ice maker to replenish.
Sabbath
This appliance is certified by Star-K to meet strict religious
regulations in conjunction with specific instructions found
on www.star-k.org.

Care Recommendations

Cleaning
STAINLESS STEEL EXTERIOR
Use a nonabrasive stainless steel cleaner and apply with a
soft lint-free cloth. To bring out the natural luster, lightly
wipe the surface with a water-dampened microfiber cloth
followed by a dry polishing chamois. Always follow the
grain of stainless steel.
INTERIOR CLEANING
To clean interior surfaces and all removable parts, wash
with a mild solution of soap, water, and baking soda. Rinse
and dry thoroughly. Avoid getting water on the lights.
CAUTION
Do not use vinegar, rubbing alcohol, or other
alcohol-based cleaners on any interior surface.
VACATIONS
For extended vacations, turn the unit off. Empty the unit
and block doors open to let fresh air in and keep the
interior dry. The water filter should be replaced before
start-up.
CONDENSER CLEANING
CAUTION
Before cleaning the condenser, turn power off to the
unit. Wear gloves to avoid injury from sharp con-
denser fins.
The condenser is located behind the grille. To access,
rotate the bottom of the grille upward. Use a soft bristle
brush and vacuum to remove dust and lint from the con-
denser. Clean the condenser every 6–12 months. Refer to
the illustration below.
IMPORTANT NOTE: To avoid damaging the condenser fins,
vacuum in the direction of the fins.
CAUTION
Failure to clean the condenser could result in tem-
perature loss, mechanical failure, or damage.
CONDENSER
Condenser location
subzero.com | 7