Advertisement
5. Attach the Roof Top. Do not over tighten the screws, or the Roof
Top Strip may split. If this happens, remove the screws and attach
with glue and tape only. This will not sacrifice the quality of this
Slot
Roof Top Edge Trim
7. Attach the Mitered Roof Top Edge
Trim (17") and the Top Front in the
6. Attach the Front and Rear Side Walls. Make sure the pre-drilled holes line
up well. These walls should be identical. But, if the holes do not line up, switch
8. Place glue in the hole on the base floor and on the top of the Fire Pole
Page 3
and carefully flex the Fire Pole into the pre-drilled holes in the floor and
Advertisement
