Table of Contents
Advertisement
Quick Links
MODEL RL2000
A
T
M
UTOMATED
ELLER
ACHINE
I
M
NSTALLATION
ANUAL
VERSION 2.0
TDN 07103-00155B 05/2008
C
H
ORPORATE
EADQUARTERS
522 E. Railroad St.
Long Beach, MS 39560
Phone: (228) 868-1317
Fax: (228) 868-0437
COPYRIGHT NOTICE
© 2007-2008 Delaware Capital Formation, Inc. All Rights Reserved. Triton Systems of Delaware Inc.
is an operating company of Dover Electronics, Inc., a subsidiary of Dover Corporation (DOV-NYSE).
DOVER, the DOVER logo and the Dover family of marks and TRITON, the TRITON logo and the
Triton family of marks are registered trademarks of Delaware Capital Formation, Inc., a wholly owned
subsidiary of Dover Corporation.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Triton RL2000
Summary of Contents for Triton RL2000
- Page 1 Dover Electronics, Inc., a subsidiary of Dover Corporation (DOV-NYSE). DOVER, the DOVER logo and the Dover family of marks and TRITON, the TRITON logo and the Triton family of marks are registered trademarks of Delaware Capital Formation, Inc., a wholly owned...
- Page 2 ANUAL NTRODUCTION The Triton RL2000 is a lobby terminal designed for indoor use only. The following sections provide the requirements for installing the RL2000 for your particular site location. To assist you in preparing your site, a check list is provided of various steps that should be carried out prior to the arrival of the ATM.
-
Page 3: Table Of Contents
RL2000 I ODEL NSTALLATION ANUAL ONTENTS ......................4 OMPLIANCE ..................5 NVIRONMENTAL RECAUTIONS / RF I ................ 6 EMPERATURE OWER NTERFERENCE EQUIREMENTS ......................... 7 IMENSIONS ................... 8 RONT USTOMER CCESS IMENSIONS ........................9 ERVICE IMENSIONS ABINET USINESS OURS ............................. 10 IEWS .......................... -
Page 4: Site Compliance
ANUAL OMPLIANCE This document contains the information necessary for the preparation and installation of an RL2000 Triton ATM. It’s important that the site complies with the requirements specified in this document. In addition, electrical wiring and mechanical systems must also comply with all relevant laws and regulations. - Page 5 RL2000 I ODEL NSTALLATION ANUAL NVIRONMENTAL RECAUTION HECKLIST...
-
Page 6: Nterference Requirements
RL2000 I ODEL NSTALLATION ANUAL When installing an ATM, some general envir onmental and power precau- tions need to be considered. Evaluate the location where the ATM will be installed. To help ensure proper operation of the ATM, ensure the environ- mental criteria listed in this checklist are met. -
Page 7: Imensions
RL2000 I ODEL NSTALLATION ANUAL IMENSIONS Dimensions listed comply with US Federal ADA Guidelines. For USA installations, check for additional guidance. For non-USA installations, check regulations relating to the country of install. Note: Dimensions shown in inches and [millimeters]... -
Page 8: Dimensions
RL2000 I ODEL NSTALLATION ANUAL HYSICAL IMENSIONS Front View " 5 " 6 " 6 " 8 " 6 l l i... -
Page 9: Ervice Rea Imensions
RL2000 I ODEL NSTALLATION ANUAL ERVICE IMENSIONS 2" [51] clearance around cabinet sides and rear ) " i l l i ) t l " 1 " 1 " 6 " 8 " 6 " 8 " 2 " 9 "... -
Page 10: Side Views
RL2000 I ODEL NSTALLATION ANUAL HYSICAL IMENSIONS EEP CABINET USINESS OURS Side Views... -
Page 11: Mid / High Toppers
RL2000 I ODEL NSTALLATION ANUAL HYSICAL IMENSIONS EEP CABINET USINESS OURS Mid Topper High Topper... -
Page 12: Side View
RL2000 I ODEL NSTALLATION ANUAL HYSICAL IMENSIONS EEP CABINET AULT Side View “F ” ABINET OOTPRINTS Anchor “footprint” - Deep cabinet (Business) Anchor “footprint” - Deep cabinet (Vault) -
Page 13: Abinet Nstallation
RL2000 I ODEL NSTALLATION ANUAL ABINET NSTALLATION... -
Page 14: Ools Equired
The following procedure applies to installing the cabinet assembly using either standard (P/N 06200-00066) or chemical (06200-00060) anchor kits. The anchor kits are not supplied with the unit. * IMPORTANT * Model RL2000 ATM is designed for indoor use only! l i r " 4 t a l "... - Page 15 10. The accessory box is shipped inside the cabinet enclosure. Then turn the dial to the right Open and inspect the contents. Check the contents against the (clockwise) until the bolt is re- enclosed packing list and report any missing parts to Triton. tracted. **WARNING** Electronic Lock. The combination...
- Page 16 RL2000 I ODEL NSTALLATION ANUAL Mark/Drill Mounting Holes SELECTING THE INSTALLATION LOCATION Mark the location of the cabinet mounting holes on the concrete Choosing the right location for your floor. This is accomplished as described below: ATM is very important. Security concerns suggest a location that is Move the ATM to the location where it will be installed.
-
Page 17: Bolt Atm
RL2000 I ODEL NSTALLATION ANUAL Use a portable vacuum cleaner to remove any dust or debris that may have fallen into the holes during the drilling process. Drill anchor holes Blow out dust/debris. Install Standard Anchors Bolt ATM to Floor 1. -
Page 18: Olt Atm
RL2000 I ODEL NSTALLATION ANUAL Place a flat washer on the anchor bolt followed by a 1/2” (13mm) nut. Repeat Steps 2 and 3 for the remaining anchor bolts. 6. Ensure the cabinet is as level as possible given the floor conditions. Use a bubble level to verify this. - Page 19 RL2000 I ODEL NSTALLATION ANUAL Insert the chisel point of the rod into the hole to break the glass capsule. Spin it into the capsule at a speed of 250 to 500 RPM, until it is fully embedded. IMPORTANT! Turn the rotary hammer drill OFF IMMEDIATELY when the rod is fully embedded! Pull the driver out of the coupling while holding the rod.
- Page 20 RL2000 I ODEL NSTALLATION ANUAL NTENTIONALLY LANK...
- Page 21 RL2000 I ODEL NSTALLATION ANUAL OUTE OWER AND OMMUNICATION...
-
Page 22: Oute Ower Oute Onnect Ables
RL2000 I ODEL NSTALLATION ANUAL Route AC Power and Communication Cable NOTE: Before you start, unlock and open the control panel. Verify that the power switch on the unit’s power supply is in the OFF (0) position. Close the control panel. - Page 23 RL2000 I ODEL NSTALLATION ANUAL Power Outlet Accessibility Whether you are installing a new AC socket outlet or plan to use an existing outlet to supply power to the ATM, make sure the following requirements are met: The outlet is located near the equipment.
- Page 24 TCP/IP (E THERNET The Ethernet option makes your RL2000 ATM LAN (Local Area Network) or WAN (Wide Area Network) capable. The ATM functions that are normally performed via the dial-up telephone system, such as customer transactions and remote monitoring, can now be performed using existing in-house communica- tions network.
- Page 25 RL2000 I ODEL NSTALLATION ANUAL VSAT (S ATELLITE VSAT stands for “Very Small Aperture Terminal” and refers to receive/transmit terminals installed at dispersed sites connecting to a central hub via satellite using small diameter antenna dishes (0.6 to 3.8 meter).
- Page 26 RL2000 I ODEL NSTALLATION ANUAL NTENTIONALLY LANK...
Need help?
Do you have a question about the RL2000 and is the answer not in the manual?
Questions and answers