Table of Contents
Advertisement
Wall Sleeve Installation Instructions (PDXWS)
Wall Sleeve Installation Instructions (PDXWSA)
NOTE:.
Insure.that.the.unit.is.only.installed.in.a.wall.structurally.adequate.to.support.the.unit.including.the.sleeve,.chassis.and.accessories...If.the.sleeve.
projects.more.than.8".into.the.room,.a.subbase.or.other.means.of.support.MUST.be.used...Please.read.these.instructions.completely.before.
attempting.installation.
Falling Object Hazard
Not following Installation Instructions for
mounting your air conditioner can result
in property damage, injury, or death.
For Deep Wall Installation (Greater than 13 1/4")
See Page 9
The.following.instructions.apply.ONLY.to.walls.less.than.13.¼".in.depth..
The.PXDR10.Drain.Kit,(optional.for.new.construction).see.page.10.
1.
if.applicable,.must.be.installed.before.the.wall.sleeve.is.installed.
into.the.wall.
The.External.Drain.(for.new.construction.or.unit.replacement).see.
2.
page. 11 if .applicable,.must.be.installed.before.the.wall.sleeve.is.
installed.into.the.wall.
Figure 3
Typical Wall Sleeve Installation
LINTEL TO SUPPORT
MASONRY WALLS
ELECTRICAL
RECEPTACLE
WALL OPENING
NOTE: All 230/208V units are manufactured with a 60" power cord and all 265V units with a 18" power cord.
29
6
INSTALLATION
WARNING
WALL SLEEVE
DO NOT allow any pitch toward the inside.
Flashing on all 4 sides of the opening is recommended.
Potential property damage can occur if instructions are
not followed.
From.inside.the.building,.position.the.wall.sleeve.in.the.opening.and.
3.
push.it.into.the.wall.until..it.protrudes.at.least.¼".on.the.outside...
(See.Figure. 9, .Page.8).
Position. the. wall. sleeve. with. a. slight. tilt. towards. the. outside. to.
4.
facilitate.condensate.drainage...It.should.be.level.side-to-side.and.
the.front.should.be.¼.bubble.higher.than.the.back.
"
16-¼
INSULATION
NOTICE
ELECTRICAL
RECEPTACLE
SMOOTH SIDE OF SCREW
CLIP FACING INTO ROOM
INSULATION
FRP008
Advertisement
Table of Contents
