Ipevo UDC-10 Quick Start Manual

Quick Start Guide
UDC-10 USB 3.0 2.5" HDD Case

1. Getting Started

Welcome
...to the UDC-10, a compact hard drive
enclosure that transforms your ordinary
2.5-inch SATA drive into a super-speed
storage device capable of transferring up
to 4.8Gbps.
The UDC-10 is ideal for editing and managing bandwidth-intensive programs such as CAD or
video editing software. The UDC-10 has the speed and power to back up important data and
store office work, digital photos, music and movies in the blink of an eye.
The UDC-10 also provides you with the following benefits:
• Backward-compatible with USB 2.0/1.1, with an indicator to show which version is in use
• Rugged metal enclosure for heat dissipation and hard drive protection
• Optimized for portable usage; lightweight, compact, and USB bus-powered
• SuperSpeed USB 3.0 interface: faster than SATA6
• Supports all 9.5mm height, 2.5 inch SATA HDD

2. Preparing the Equipment

Double-check the package contents, and make sure your computer environment meets
the system requirements.
Package contents*
• UDC-10 USB 3.0 2.5" HDD case
• USB 3.0 Micro-B cable
• Screwdriver
• Quick Start Guide (this document)
*A hard drive is not included in this package.
System requirements
2.5-inch SATA I/II HDD (9.5mm height)*
< For a USB 3.0 connection >
• A computer with a USB 3.0-certified
motherboard or adapter card
• Windows 7/Vista/XP
• Available USB 3.0 port
< For a USB 2.0/1.1 connection >
• Windows 98 / Mac OS 9.0 or above, Linux
• Available USB port
* A 12.5mm-height drive will not fit into the case.

3. Installing the UDC-10

Follow these steps to connect everything together: Your UDC-10, your hard drive, and your
computer.
Front view
Front screw x 2
Step 1: Disassemble the case
Loosen the two screws on the front panel (see the diagram above) using the screwdriver
in the package. Pull the front panel away from the case.
Step 2: Insert the SATA drive into the case
Connect your hard drive and the front panel, make sure they are firmly assembled. Insert
them into the case and tighten the front screws.
Step 3: Connect the UDC-10 to your computer
Use the USB 3.0 cable to connect the UDC-10 to your computer. When the OS recognizes
the hard drive, the LED indicator will turn on.
Continue to Section 4, Accessing Drive Data
hard drive work with your computer.
USB 3.0 connector LED indicator
on the back to verify that the UDC-10 and your