Amico Hummingbird User Manual page 40

Section 8: Troubleshooting, Preventative Maintenance,
Storage, & Cleaning
Troubleshooting
Symptom
Advanced Interface is blank
Automatic Height Adjustment is not
working
Both Arrow Keys flashing (STD. Interface)
Home Icon Crossed Out (ADV. Interface)
Single Arrow Key (up or down) flashing
(Standard Interface only)
Warning icon appears (Advanced
Interface only)
Difficulty steering the cart
Difficulty closing the Work Surface
If the above solutions do not solve your symptoms or you are in need of parts/hardware, please contact Amico
Accessories, 1-877-264-2697.
37 Amico Accessories Inc.
Possible Cause
• Loose/disconnected cable
• Cart's batteries are drained
• Interface is frozen
• Cart has not yet been initialized
• Batteries have no charge
• Cart is already in the lowest/highest
position
• Connection to the interface is loose/
disconnected
• Loss of/no home position set
• Home position has been lost
• Collision detected
• Casters are sticky/covered in debris
• Casters are locked
• Casters are damaged
• Devices/objects in the Main Bin are
too large
• Lock is engaged
• FIT Access Door is open
Solution
• Open the Work Surface (see page 27) and
check connection to the interface
• Plug in the cart to charge the batteries
• If the cart is equipped with a Reset
Switch, activate switch to reset system.
If the cart is not equipped with a Reset
Switch, briefly disconnect the Interface
Cable from inside of the Main Bin, then
reconnect to force an interface reset.
• Initialize the cart (see pages 4, 24-25)
• Charge the batteries by plugging it into a
nearby outlet
• If the cart is already in the highest or
lowest position, it cannot be further
elevated or lowered (respectively).
Reverse the direction of the height
adjustment
• Open the Work Surface (see page 27) and
check the connection to the interface
• . Hold the Down Arrow until the cart
reaches bottom (if cart is unable to move
upwards only).
• Clear any obstacles preventing height
adjustment. Adjust the cart slightly in
the opposite direction than desired, then
resume use in desired direction.
• Unlock the casters
• Clean the caster
• Contact Amico Accessories for a
replacement
• Ensure objects in the Main Bin are within
the specified size range
• Ensure the lock is disengaged (turned
counterclockwise) prior to closing the
Work Surface
• Ensure the FIT Access Door is closed and
not interfering with the Work Surface