Operation; Use Of The Control Panel; Modifying The User Parameters; Starting Up The Boiler - Baxi POWER HT+ 1.50 User Manual

5

Operation

5.1

Use of the control panel

Fig.6
18. February 2014
Tuesday
1.5 bar
MENU
5.2

Starting up the boiler

5.3

Stopping the boiler

5.4

Frost Protection

7609475 - v09 - 22072020
14:13
MENU
MW-3000052-EN-02
5.1.1

Modifying the user parameters

1. Press the key to access the parameters.
MENU
Important
Press the key to return to the main display.
MENU
The user parameters can now be accessed. Use the
select and modify them.
For more information, see
List of parameters, page 19
1. Open the gas cock.
2. Start up the boiler by pressing the ON/OFF switch.
3. Press the key to access the shortcuts menu.
4. Select the Standby/operation parameter by turning the
5. Press the button to start up the boiler.
The symbol disappears.
Important
Choose the operating mode Off or Standby.
1. Switch off the boiler by pressing the ON/OFF switch.
2. Close the gas cock.
5.3.1

Putting the boiler in Standby mode

1. Press the key to access the shortcuts menu.
2. Select the Standby/operation parameter by turning the
3. Press the button to put the boiler in standby.
The symbol is displayed.
The electronic management system of the boiler includes protection
against frost. If the water temperature falls below 5°C, the burner starts up
in order to provide a water temperature of 30°C.
This function only works if the boiler is turned on, the gas supply open and
the hydraulic pressure correct.
5.4.1

Activating the Off

1. Press the key to access the shortcuts menu.
2. Select the parameter Central heating mode CH1 by turning the
button.
3. Confirm the selection by pressing the
4. Select the parameter Off by turning the
5 Operation
button to
button.
button.
button.
button.
POWER HT + 17