Advertisement
Installation (cont.)
6. Apply thread sealant tape to the
threading on the shut off valves before
connect both hot and cold water supply
hoses to the valves.
IMPORTANT :
- Make sure the water supply hoses are
connected to the corresponding valves -
i.e. cold water hose to the cold water valve
and the same for hot water hose. The
mixing valve will not function properly if the
hoses are installed incorrectly.
- Before hanging the shower panel on
the wall. Turn on both valves and test all
functions on the shower panel and check
for leaks at this point. You should have
good water flow to the shower panel and
full temperature control from the knobs.
7. Once the shower panel has been tested
for functions and leaks. Hang the unit on
the wall to complete the installation. Due to
the limited space behind the shower panel,
do not bend the hoses. Any restrictions in
the water supply hoses will greatly reduce
the performance of the shower panel. After
the shower panel is set properly on the
wall, apply silicon sealant on both sides of
the shower panel to prevent the unit from
moving.
(NOTE: Do not seal the bottom of the
panel.)
Decor Star
9
PL-037-SS Rev. A2 102017
Advertisement
