Table of Contents
Advertisement
BEKOMAT
®
33iU / 33iU CO
10.3.3 Visual inspection
During the visual inspection of the BEKOMAT
damaged components immediately.
10.3.4 Leakage test
The leakage test is a non-destructive test method and is used to prove leak tightness in vacuum and overpressure
systems. The leakage test can be carried out in different ways. BEKO TECHNOLOGIES provides no recommendations
for selecting a testing process. The operator of the pressurised system is responsible for the selection and specification
of the test method to be used, which should be executed in corresponding to with valid standards and regulations (e.g.
DIN EN 1779).
10.3.5 Cleaning
CAUTION
NOTE
1.
Proper shutdown of the BEKOMAT
1.
Spray mild detergent onto a cotton cloth or disposable tissue until it is damp (not wet).
2.
Rub the surfaces of the product with the damp cloth.
3.
Begin operation of the product.
54 | 68
®
, inspect all components for mechanical damage and corrosion. Replace
Inappropriate cleaning and use of the wrong cleaning media!
Inappropriate cleaning and the use of the wrong cleaning media may result in minor injuries
as well as damage to health and damage to property.
•
Never clean the device with a dripping wet cloth.
•
Never use abrasive or aggressive detergent or solvents which could damage the outer
coating (e.g. markings, type plate, corrosion protection, etc.).
•
Never clean the device with hard or pointed implements.
•
Use an anti-static, damp cloth for cleaning the outside.
•
Immediately replace any product markings (pictograms, markings) that have become
illegible.
Local hygiene regulations!
In addition to the cleaning instructions listed, any regionally applicable hygiene regulations
must be observed.
Preparatory tasks
is completed.
®
Cleaning work
Original installation and operation manual
Advertisement
Table of Contents
