Sony DVP-NS400D Operating Instructions Manual page 78

xLEVEL
You can vary the level of each speaker as
follows. Be sure to set "TEST TONE" to
"ON" for easy adjustment.
The default adjustments are in parentheses.
CENTER
(0dB)
REAR (0dB)
SUBWOOFER
(0dB)
To adjust the volume of all the
speakers at one time
Use the amplifier's (receiver's) volume control.
xTEST TONE
The speakers will emit a test tone. Use this
when you use the 5.1CH OUTPUT jacks and
adjust the "BALANCE" and "LEVEL."
OFF
ON
Adjusting the speaker volume and level
1
After you stop playback, select
"SPEAKER SETUP" in the Setup Display.
2
Select "TEST TONE" and set "TEST
TONE" to "ON."
You will hear the test tone from each
speaker in sequence.
78
Adjust the level of the centre
speaker (–6dB to +6dB, 0.5dB
increments).
Adjust the level of the rear
speakers (–6dB to +6dB,
0.5dB increments).
Adjust the level of the
subwoofer (–10dB to +10dB,
0.5dB increments).
The test tone is not emitted from
the speakers.
The test tone is emitted from each
speaker in sequence while
adjusting balance or level.
When you select one of the
"SPEAKER SETUP" items, the
test tone is emitted from both left
and right speakers simultaneously.
3
From your listening position, select
"BALANCE" or "LEVEL" and adjust the
value of "BALANCE" using C/c and
"LEVEL" using X/x.
The test tone is emitted from both left and
right speakers simultaneously.
4
Select "TEST TONE" and set "TEST
TONE" to "OFF" to turn off the test tone.
Note
When you adjust the speaker settings, the sound cuts
off for a moment.