Bison TN10P Instruction Manual

Item Qty Description
A 1 Winch Post
B 1 Non-Winch Post
C 1 Removable Winch Handle
D 1 TN10NP Tennis Net
E 3 Spreader Tube
F 4 Inner Tube
G 2 Stabilizer Leg
H 2 Clamp
I 8 5/16" X 3/4" Button Head Bolt
J 4 Wheel
K 2 1/2" X 7 1/2" Hex Bolt

Inspect all contents prior to installation. Report any missing parts to dealer immediately

Read all instructions before proceeding.
1. Slide the Connecting Bar (M) into the Inner Tube (F) through the channel so that all the holes are lined up
as shown. Insert the inner tube assembly into either the Winch Post (A) or the Non Winch Post (B) leaving
six holes exposed for the Spreader Tube (E) attachment. Using two of the 3/8" X 1" Hex Bolts (N) loosely
attach the inner tube assembly to the Winch Post (A). Slide a Spreader Tube (E) over the exposed portion
of the inner tube assembly and attach it using two more 3/8" X 1" Hex Bolts (N). Continue the same
process with two more Spreader Tubes (E) followed by the Non Winch Post (B). Tighten all of the 3/8" X
1" Hex Bolts (N). See Figures 1 & 7.
2. Loosen the set screws that secure the lacing bars to the Winch Post (A) and the Non Winch Post (B). Slide
the lacing bar up, then using the 5/16" X 3/4" Button Head Bolts (I) attach the Clamp (H) to the Stabilizer
Leg (G) Assembly. Leave the 5/16" X 3/4" Button Head Bolts (I) hand tight. Slide the lacing bar back in
its original position and tighten the set screw. See Figure 2.
3. Remove one of the 3/8" X 1" Hex Bolts (N) on the middle Spreader Tube (E). Slide the 5/16" X 1"
Carriage Bolts (O) down the groove in the Spreader Tube (E) towards the middle. Replace 3/8" X 1" Hex
Bolt (N). Measure approximately 77 7/8" from the end of the middle Spreader Tube (E) and make a small
mark. Place the TN10P Center Strap Anchor (S) over the 5/16" X 1" Carriage Bolts (O). Line the edge of
the TN10P Center Strap Anchor (S) up with the mark made earlier. Tighten it down to the Spreader Tube
(E) using the 5/16" Flat Washers (P), 5/16" Lock Washers (Q), and the 5/16" Hex Nuts (R).
See Figures 3 & 4.
Date: 3/13/20 Rev: 1
—— Instruction Manual ——
TN10P
Competition Portable Tennis System
P A R T S L I S T
B.A. N.J.C.
Item Qty Description
L 2 1/2" Lock Nut
M 4 Connecting Bar
N 16 3/8" X 1" Hex Bolt
O 2 5/16" X 1" Carriage Bolt
P 2 5/16" Flat Washer
Q 2 5/16" Lock Washer
R 2 5/16" Hex Nut
S 1 TN10P Center Strap Anchor
T 1 TN10CS Center Court Hold Down Strap
U 2 Lacing Cord
File: \pub\TN10P
1
.
Ref#: 960941