Sony DVP-F25 Operating Instructions Manual page 50

TVS DYNAMIC
Creates virtual rear speakers from the sound
of the front speakers (L, R) without using
actual rear speakers (shown below).
This mode is effective when the distance
between the front L and R speakers is short,
such as with built-in speakers on a stereo TV.
TVS WIDE
Creates virtual rear speakers from the sound
of the front speakers (L, R) without using
actual rear speakers. The virtual speakers are
reproduced as shown in the illustration
below.
This mode is effective when the distance
between the front L and R speakers is short,
such as with built-in speakers on a stereo TV.
TVS NIGHT
Large sounds, such as explosions, are
suppressed, but the quieter sounds are
unaffected. This feature is useful when you
want to hear the dialog and enjoy the
surround sound effects of "TVS WIDE" at
low volume.
50
TV
TV
TVS STANDARD
Creates virtual rear speakers from the sound
of the front speakers (L, R) without using
actual rear speakers. The virtual speakers are
reproduced as shown in the illustration
below. Use this setting when you want to use
TVS with 2 separate speakers.
L
L : Front speaker (left)
R : Front speaker (right)
: Virtual speaker
Notes
• When the playing signal does not contain a signal
for the rear speakers, the surround effects will be
difficult to hear.
• When you select one of the TVS modes, turn off
the surround setting of the connected TV or
amplifier (receiver).
• Make sure that your listening position is between
and at an equal distance from your speakers, and
that the speakers are located in similar
surroundings.
• "TVS NIGHT" only works with Dolby Digital
discs. However, not all discs will respond to the
"TVS NIGHT" function in the same way.
• When you use the DIGITAL OUT (OPTICAL)
jack to listen to MPEG audio signals and set
"MPEG" to "MPEG" in "AUDIO SETUP," no
sound will come from your speakers if you select
one of the TVS modes.
R