Tv Virtual Surround Settings (Tvs) - Sony DVP-F25 Operating Instructions Manual

Checking the audio signal
format
If you press DISPLAY repeatedly during
playback, the format of the current audio
signal (Dolby Digital, MPEG audio, DTS,
PCM, etc.) appears as shown below.
Example:
Dolby Digital 5.1 ch
DOLBY DIGITAL
Front (L/R)
LFE (Low Frequency
+ Centre
Effect)
About audio signals
Audio signals recorded in a disc contain the
sound elements (channels) shown below.
Each channel is output from a separate
speaker.
• Front (L)
• Front (R)
• Centre
• Rear (L)
• Rear (R)
• Rear (Monaural): This signal can be either
the Dolby Surround Sound processed
signals or the Dolby Digital sound's
monaural rear audio signals.
• LFE (Low Frequency Effect) signal
Note
If "DTS" is set to "OFF" in "AUDIO SETUP," the
DTS track selection option will not appear on the
screen even if the disc contains DTS tracks (
68
).
Rear (L/R)
3 / 2 .1
page
TV Virtual Surround
Settings
(TVS)
When you connect a stereo TV or 2 front
speakers, TVS (TV Virtual Surround) lets
you enjoy surround sound effects by using
sound imaging to create virtual rear speakers
from the sound of the front speakers (L: left,
R: right) without using actual rear speakers.
TVS was developed by Sony to produce
surround sound for home use using just a
stereo TV.
1
Press SUR during playback.
The following Control Bar appears.
TVS DYNAMIC
2
Press SUR repeatedly to select
one of the TVS sounds.
Refer to the following explanations given
for each item.
• TVS DYNAMIC
• TVS WIDE
• TVS NIGHT
• TVS STANDARD
To cancel the setting
Select "OFF" in Step 2.
49
c continued